ProBoat BlackJack 26 SS Nitro
After verifying the boat ran I tore it down and started working on repairing the hull
I reinforced the sides of the engine well with fiberglass cloth and epoxy. To patch the bottom I used a motor tool to grind away the chipped gelcoat and then put epoxy over the rough surface. I covered the patch with wax paper and pressed it down to get the spot even and smooth. When the wax paper was removed I had minimal sanding to do. I also filled the holes for the factory turn fins as I would not be using them.
Inside of hull painted, and a few engine photos.
Here the boat is back together, and ready to run.